DNC and CNC setting for Heidenhain-TNC 415B


These settings for DNC Precision software only. It may not work with other software.

Set the following parameters on the machine

Interface typeEXT2
Baud rate9600
MP5200.1 (external device)2
MP5201.1 (external device)3
MP5020.1104
MP5030.10

Set the following parameters on the PC

Serial port tab

Machine nameHeidenhain-TNC 415B
Serial portCOM2 (or any free COM port)
Baud2400
Data bits7
ParityEven
Stop bits2

Data flow control tab

Use DTRFalse
Use RTSTrue
Require DSRFalse
Require CTSTrue
Set RTSFalse
Set DTRFalse
Software flowcontrolNone
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start:
Program end:
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No

Null modem cable, without handshake
PC, 9pin, DB9M CNC, 25pin, DB25
PC DB9 - CNC DB25
Null modem cable, with full handshake
PC, 9pin, DB9M CNC, 25pin, DB25
PC DB9 - CNC DB25
Null modem cable, without handshake
PC, 25pin, DB25M CNC, 25pin, DB25
PC DB25 - CNC DB25
Null modem cable, with full handshake
PC, 9pin, DB25M CNC, 25pin, DB25
PC DB25 - CNC DB25

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.