Server software for Easy-Track GPS Trackers, Vehicle trackers, AVL units
Easy-Track
| Parser item name | Data type | Description |
|---|
| FULL_DATA_PACKET | String | One message from a data packet |
| DATA_PACKET | String | Same as FULL_DATA_PACKET, but without data packet signatures (if exist) |
| DATE_TIME_STAMP | DateTime | Datetime stamp |
| DATA_SOURCE_ID | Integer | Data source ID |
| DATA_SOURCE_NAME | String | Data source name |
| DATA_SOURCE_FULL_NAME | String | Data source full name |
| CLIENTID | Integer | Tracker's remote IP address and port |
| IMEI | String | IMEI |
| DEVICE_ID | String | Device ID |
| RECORD_TYPE | String | Record type |
| GPS_STATE | String | GPS state |
| GPS_STATE_NAME | String | GPS state name |
| TIMESTAMP_UTC | DateTime | UTC date and time |
| TIMESTAMP | DateTime | Local date and time |
| LATITUDE | Float | Latitude 1) |
| LATITUDE_DEG | String | Latitude (format: deg/min/sec) |
| LONGITUDE | Float | Longitude 1) |
| LONGITUDE_DEG | String | Longitude (format: deg/min/sec) |
| SPEED | Float | Speed |
| ANGLE | Float | Course |
| STATE | String | Device state |
| STATE_POWER | Boolean | State: external power |
| ALARM_GEOFENCE_IN | Boolean | Alarm: geofence in |
| ALARM_GEOFENCE_OUT | Boolean | Alarm: geofence out |
| ALARM_BATTERY_LOW | Boolean | Alarm: battery low |
| ALARM_GPS | Boolean | Alarm: GPS |
| STATE_MOVEMENT | Boolean | State: movement |
| STATE_DRIVING | Boolean | State: driving |
| ALARM_OVER_SPEED | Boolean | Alarm: over speed |
| ALARM_SOS | Boolean | Alarm: SOS |
| ALARM_MOVEMENT | Boolean | Alarm: movement |
| ALARM_POWER | Boolean | Alarm: power down |
| STATE_ENGINE_OFF | Boolean | State: engine off |
| STATE_DOOR | Boolean | State: door |
| ALARM_STEAL | Boolean | Alarm: steal |
| STATE_POWER_SAVING | Boolean | State: power saving mode |
| STATE_IGNITION | Boolean | State: ignition |
| GSM | Integer | GSM |
| VIN | Integer | Battery level (%) |
| FUEL | Integer | Fuel |
| TRACK | Float | Mileage |
| ALTITUDE | Integer | Altitude |
1) The value is being calculated using the following formula:
d - degree
m - minutes
s - seconds
ms - milliseconds
If a longitude is west or a latitude is south, then the value is being multiplied by –1.