Logging and capturing data from Ohaus Aviator (NCI Protocol).


This data is being extracted with help of the "Advanced Serial Data Logger" software only. It may not applicable for other software titles.

DescriptionData typeColumn name
WeightfloatWEIGHT
Weight unitsstringWEIGHT_UNITS

COM port settings

Note 1: Check the Instruction Manual and see the RS232 menu option on your scale.

Note 2: Your COM port settings should match the RS232 settings on the scale.

COM Port Number: Select the port to which your instrument is connected.
Baud rate: 600, 1200, 2400, 4800, 9600 or 19200 (check the scale's RS232 menu)
Data bits: 7 or 8
Parity: Odd or Even.
Flow control: hardware and software flow control is disabled.

How to configure the logger for the Ohaus Aviator (NCI Protocol).

1. Download and install the "Scale data parser" module.
2. Create or modify existing configuration.
3. Go to the "Modules - Query Parse Filter" page
4. Select the corresponding parser module.

The parser for Ohaus Aviator (NCI Protocol)

Ohaus Aviator (NCI Protocol) (unipsarser.dll)

Ohaus Aviator (NCI Protocol) (unipsarser.dll)


The communication setting

Note: Your COM port settings above should match the RS232 settings on the scale.

How to write data from the Ohaus Aviator (NCI Protocol) to a database.

Please, visit our tutorials section for examples.

How to capture data from USB scale or balance?

Usually the scale vendor provides a driver that can create a virtual COM port for the usb scale. Our serial data logger fully supposts virtual COM ports.

Go to Index page

Note: Products and companies mentioned here are used only for definition and identification purposes and can be trademarks and/or registered trademarks of the respective companies.