DNC and CNC setting for Anilam Crusader II M
These settings for DNC Precision software only. It may not work with other software.
Set the following parameters on the machine
| 7 data bits | AUX 2767 |
| Even parity | AUX 2772 |
| Baud rate 4800 | AUX 2787 |
| Software handshake (Xon, Xoff) | AUX 2791 |
| Hardware handshake (DTR, DSR) | AUX 2792 |
| Transfer from NC to PC in RS-274 format | AUX 2700 |
| Transfer from PC to NC in RS-274 format | AUX 2701 |
|
Set the following parameters on the PC
Serial port tab
| Machine name | Anilam Crusader II M |
| Serial port | COM2 (or any free COM port) |
| Baud | 4800 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
Data flow control tab
| Use DTR | True |
| Use RTS | False |
| Require DSR | True |
| Require CTS | False |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | None |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start: %
Program end: %
Line start:
Line end: #0A
Skip lines: ;
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: :
Program starting characters in the file: No
Program ending characters in the file: No |
| Null modem cable, without handshake |
| PC, 9pin, DB9M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, with full handshake |
| PC, 9pin, DB9M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, without handshake |
| PC, 25pin, DB25M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, with full handshake |
| PC, 9pin, DB25M |
CNC, 25pin, DB25 |
|
|
If you have successfully connected DNC Precision
with any other controller not in this list, we would appreciate
your sending us the
details to add to the list.
Note: We are not
responsible and do not provide guarantee for any of these
settings, that have been sent us by our customers.
