DNC and CNC setting for Mazak - Fusion 640M

These settings are for the DNC Precision software only. They may not work with other software.

Set the following parameters on the machine

Baud rate9600
Data bits7
ParityEven
Stop bits2
HandshakeDC control
Wait time45 sec
Format7
Same Wno.ALARM
PortCOM1
TAP11
TAP20
TAP30
TAP40
TAP51
TAP60
TAP70
TAP88
TAP976
TAP1013
TAP11109
TAP12122
TAP1391
TAP1470
TAP150
TAP160
TAP170
TAP180
TAP190
TAP200
TAP210
TAP220
TAP230
TAP240
TAP2500000000
TAP2600000001
TAP2700000000
TAP2800111010
TAP2910
TAP3030
TAP310
TAP320

Set the following parameters on the PC

Serial port tab

Machine nameMazak - Fusion 640M
Serial portCOM2 (or any free COM port)
Baud9600
Data bits7
ParityEven
Stop bits2

Data flow control tab

Use DTRFalse
Use RTSTrue
Require DSRFalse
Require CTSTrue
Set RTSFalse
Set DTRFalse
Software flowcontrolBoth
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start: %
Program end: %
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No

Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
 

Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
 

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.