DNC and CNC setting for Mazak - Fusion 640T

These settings for DNC Precision software only. It may not work with other software.

Set the following parameters on the machine

Baud rate 9600 Data bits 7 Parity Even Stop bits 2 Handshake DC control Wait time 45 sec Format 7 Same Wno. ALARM Port COM1 TAP1 1 TAP2 0 TAP3 0 TAP4 0 TAP5 1 TAP6 0 TAP7 0 TAP8 8 TAP9 76 TAP10 13 TAP11 109 TAP12 122 TAP13 91 TAP14 70 TAP15 0 TAP16 0 TAP17 0 TAP18 0 TAP19 0 TAP20 0 TAP21 0 TAP22 0 TAP23 0 TAP24 0 TAP25 00000000 TAP26 00000001 TAP27 00000000 TAP28 00111010 TAP29 10 TAP30 30 TAP31 0 TAP32 0

Set the following parameters on the PC

Serial port tab

Machine name	Mazak - Fusion 640T
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	Both
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: % Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Null modem cable, without handshake PC, 9pin, DB9M CNC, 25pin, DB25

Null modem cable, without handshake PC, 25pin, DB25M CNC, 25pin, DB25

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.