DNC and CNC setting for Okuma - Okuma 100-EL
These settings for DNC Precision software only. It may not work with other software.
Set the following parameters on the machine
Tape puncher interface
| Parameter | Value |
| A1 (tape code) | ISO |
| A2 (detect code automatically) | No |
| A3 (tape TV check) | No |
| A4 (enter tape code in ISO) | LF |
| A5 (tape delimiting) | % |
| A6 (special code) | Alarm |
| A7 (operation file name) | Punch |
| A8 (tape feed) | Space feed |
| A9 (tape feed holes) | 50 |
|
Tape interface (RS232 parameters)
| Parameter | Value |
| B1 (baud rate) | 4800 |
| B2 (data bits) | 8 |
| B3 (parity) | None |
| B4 (stop bits) | 1 |
| B5 (ready time) | 50 |
| B6 (flow control) | RTS/CTS |
| B7 (RS timeout) | 20 |
| B8 (transfer timeout) | 20 |
| B9 (DC2/DC4) | No |
| B10 (DC3 when finished) | No |
|
Read/Write
| Parameter | Value |
| 1 (device number) | CN0 |
| 2 (tape delimiting code) | Null |
| 3 (stop bits) | 1 |
| 4 (parity) | None |
| 5 (baud rate) | 4800 |
| 6 (flow control) | RTS/CTS |
| 7 | 8 bit JIS |
| 8 (ready time) | 50 |
| 9 (data bits) | 8 |
|
|
Set the following parameters on the PC
Serial port tab
| Machine name | Okuma - Okuma 100-EL |
| Serial port | COM2 (or any free COM port) |
| Baud | 4800 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
Data flow control tab
| Use DTR | False |
| Use RTS | True |
| Require DSR | False |
| Require CTS | True |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | None |
| Xon char | #11 |
| Xoff char | #13 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start: %
Program end: %
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No |
| Null modem cable, without handshake |
| PC, 9pin, DB9M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, with full handshake |
| PC, 9pin, DB9M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, without handshake |
| PC, 25pin, DB25M |
CNC, 25pin, DB25 |
|
|
| Null modem cable, with full handshake |
| PC, 9pin, DB25M |
CNC, 25pin, DB25 |
|
|
If you have successfully connected DNC Precision
with any other controller not in this list, we would appreciate
your sending us the
details to add to the list.
Note: We are not
responsible and do not provide guarantee for any of these
settings, that have been sent us by our customers.
