DNC and CNC setting for Siemens - Sinumerik 3T

These settings for DNC Precision software only. It may not work with other software.

Set the following parameters on the machine

411 1110 1111 412 1110 1111 Change only following bits in the parameter #416 bit 7 1 bit 0 1 If you want you can change baud rate Baud Parameter value 600 1110 1011 1200 1110 1100 2400 1110 1101 4800 1110 1110 9600 1110 1111

Set the following parameters on the PC

Serial port tab

Machine name	Siemens - Sinumerik 3T
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: M30 Line start: Line end: #0D#0A Skip lines: ; Ignore characters: No characters for remove Remove blank lines: Yes Program name prefix: MPF Program starting characters in the file: No Program ending characters in the file: Yes

Null modem cable, without handshake PC, 9pin, DB9M CNC, 25pin, DB25	Null modem cable, with full handshake PC, 9pin, DB9M CNC, 25pin, DB25
Null modem cable, without handshake PC, 25pin, DB25M CNC, 25pin, DB25	Null modem cable, with full handshake PC, 9pin, DB25M CNC, 25pin, DB25

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.