Logging and capturing data from Radwag Scale.

This data is being extracted with help of the "Advanced Serial Data Logger" software only. It may not applicable for other software titles.

Description	Data type	Column name
Stability flag	string	STABILITY
Weight	float	WEIGHT
Weight units	string	WEIGHT_UNITS

RS 232 PARAMETERS

COM Port Number: Select the port to which your instrument is connected.
Baud rate: 2400 - 38400 (recommended). Enter the submenu <P2.Prnt> and then verify or change the baud rate
Data bits: 8
Parity: None.
Hardware flow control: Use DTR - enabled.
Software flow control: Disabled (none).

How to configure the logger for the Radwag Scale.

1. Download and install the "Scale data parser" module.
2. Create or modify existing configuration.
3. Go to the "Modules - Query Parse Filter" page
4. Select the corresponding parser module.

Radwag Scale (unipsarser.dll)

Note: Your COM port settings above should match the RS232 settings on the scale.

How to write data from the Radwag Scale to a database.

Please, visit our tutorials section for examples.

How to capture data from USB scale or balance?

Usually the scale vendor provides a driver that can create a virtual COM port for the usb scale. Our serial data logger fully supposts virtual COM ports.

Go to Index page

Note: Products and companies mentioned here are used only for definition and identification purposes and can be trademarks and/or registered trademarks of the respective companies.