DNC and CNC setting for Mikron CNC

These settings are for the DNC Precision software only. They may not work with other software.

Set the following parameters on the PC

Serial port tab

Machine nameMikron CNC
Serial portCOM2 (or any free COM port)
Baud38400
Data bits8
ParityNone
Stop bits1

Data flow control tab

Use DTRFalse
Use RTSFalse
Require DSRFalse
Require CTSFalse
Set RTSTrue
Set DTRTrue
Software flowcontrolNone
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start:
Program end:
Line start:
Line end:
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix:
Program starting characters in the file: No
Program ending characters in the file: No

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.