DNC and CNC setting for Okuma - Okuma OSP-U100

These settings for DNC Precision software only. It may not work with other software.

Set the following parameters on the machine

Optional parameters Parameter Value 1 (tape code) ISO 2 (detect code automatically) 1 (Yes) 3 (tape TV check) 0 (No) 4 (program end code) 1 (%) 5 (tape ready verify) 0 (No) 6 (special code) 0 (No alarm) 7 (ignore special code) 1 (Ignore) 8 (file name output) 0 (Output) 9 (EOR code) 0 (CR,LF) 10 (punch empty character) 0 (Null) 11 (read device number) 0 (CN0) 12 (punch device number) 0 (CN0) 10 (tape feed) 1 With help of the [PAGE DOWN] button go to tape interface (RS232 - CN0) parameters Parameter Value 1 (stop bits) 1 2 (parity check) 0 3 (parity) 1 (Even) 4 (8 bit JIS) 1 (Yes) 5 (DC2/DC4) 0 (No) 6 (file name read) 1 (Execute) 7 (CNC slave) 0 (No, master) 8 (baud rate) 9600 9 (busy timeout) 15

Set the following parameters on the PC

Serial port tab

Machine name	Okuma - Okuma OSP-U100
Serial port	COM2 (or any free COM port)
Baud	9600
Data bits	7
Parity	Even
Stop bits	2

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	None
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: % Program end: % Line start: Line end: #0D#0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

Null modem cable, without handshake PC, 9pin, DB9M CNC, 25pin, DB25

Null modem cable, without handshake PC, 25pin, DB25M CNC, 25pin, DB25

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.