SMDR, CDR data captured by Advanced PBX Data Logger from Samsung iDCS 100
This data is being extracted with help of the "Advanced PBX Data Logger" software only. It may not applicable for other software titles.
| Description | Data type | Column name |
|---|
| EXT | string | EXT |
| CO | string | TRUNK |
| Call time | datetime | CALL_TIME |
| Call duration | datetime | CALL_DURATION |
| Call duration (s) | integer | CALL_DURATION_S |
| Call type | string | CALL_TYPE |
| Direction | string | DIRECTION |
| Phone | string | DIALED_PHONE |
| Caller phone | string | CALLER_PHONE |
| Acc | string | ACC |
Samsung OfficeServ/iDCS programming codes
MMC830
IP Address - e.g. 192.168.01.20
Subnet Mask - usually 255.255.255.0 (same network)
LAN Gateway - e.g. 192.168.1.3
Card Reset - YES
MMC 829
[01]. SMDR - Destination set to PC (Port 5100)
[02]. UCD Report - Destination set to PC (Port 5101)
[06]. Periodic UCD - Destination set to PC (Port 5105)
then Update LAN - YES
MMC 725. Turn on all options except Page header
MMC 210
PERI UCD Report - On
PERI UCD SIO - Off
MMC 501. PERI UCD Report. Set to 03 sec
MMC 722. Assign ACD Group Supervisor key to keyset(s) and set up auto clearing of data at 23:59pm each night, and auto-printing every hour. (If you do not do this, then the Reports in ACD Supervisor will not work).
Note: Products and companies mentioned here are used only for definition and identification purposes and can be trademarks and/or registered trademarks of the respective companies.
