DNC and CNC setting for Bosch alpha 3


These settings for DNC Precision software only. It may not work with other software.

Set the following parameters on the machine

You need to set the baud rate = 1200
Select edit parameters mode [MODE] [N+1]
Output current the 'Baud' parameter value [A+1] [A+1]
Clear current value
Set parameter value = 7
Save changes
The baud rate can be:
50 bps0
75 bps1
110 bps2
134.5 bps3
150 bps4
200 bps5
600 bps6
1200 bps7
1800 bps8
2000 bps9
2400 bps10
3600 bps11
4800 bps12
7200 bps13
9600 bps14

Set the following parameters on the PC

Serial port tab

Machine nameBosch alpha 3
Serial portCOM2 (or any free COM port)
Baud1200
Data bits7
ParityEven
Stop bits2

Data flow control tab

Use DTRFalse
Use RTSTrue
Require DSRFalse
Require CTSTrue
Set RTSFalse
Set DTRFalse
Software flowcontrolNone
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start:
Program end:
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No

Null modem cable, without handshake
PC, 9pin, DB9M CNC, 25pin, DB25
PC DB9 - CNC DB25
Null modem cable, with full handshake
PC, 9pin, DB9M CNC, 25pin, DB25
PC DB9 - CNC DB25
Null modem cable, without handshake
PC, 25pin, DB25M CNC, 25pin, DB25
PC DB25 - CNC DB25
Null modem cable, with full handshake
PC, 9pin, DB25M CNC, 25pin, DB25
PC DB25 - CNC DB25

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.