AGG Software
Ask a question  Top  Previous  Next

Data view change

The data in the main window (fig.1.1.1) can be displayed in two modes (fig. 3.1.1):

 

1.The data can be displayed before processing. Before processing the data I fully comply with that has been read.
2.The data can be displayed after processing.  After processing the data can be modified depending on the parser.

 

options data view mode

Fig. 3.1.1. Data view

 

Data view settings, that can be configured on the "Data view" tab:

 

1.View characters with code - the program can interpret and decode bytes as characters. You can select decoding mode for each characters range. If the range doesn't have the corresponding character, that's why these data can be displayed only in hexadecimal and decimal code.
2.You can set up data  byte display users format. The directive %d shows to display an decimal code, the directive %x  - hex code. You can set any framing characters before/after the user format.
3.Highlight data sent on screen - string with sent data will be highlighted by the set color.
4.Character set - allows to define the character set of incoming data. Windows - Windows ANSI character set, DOS - OEM character set.
5.Data source custom color - if you've created several configurations then you can define a custom color for each data source that allows to distinguish data flows on the "All data" page in the main window.
6.Split strings by data timeout - this option allows to visually split data packets in the program window. A data packets that will be received after the specified interval will be showed on a new line. If this value is set to 0 then data packets will not split.
7.Split continuous data blocks large than - this option allows to visually split continuous data flow in the program window. The program will show data from a new line every specified interval.
8.Split by characters - this option allows to visually split continuous data flow in the program window using the specified symbols. For example (fig. 3.1.1), the program will use a character with the 0Ah hexadecimal code that is equal to the "LF" ASCII code.



Copyright © 1999-2016, AGG Software.
All rights reserved.