Siemens Hicom-150 OfficeCom. SMDR/CDR data format and connection settings
This data is being extracted with help of the "Advanced PBX Data Logger" software only. It may not applicable for other software titles.
This information is applicable for all 150 series models including: Hicom 150, Hicom 150 E (150E), Hicom 150 H OfficePoint, Hicom 150 H OfficePro, Hicom 150 H OfficeCom.
In OfficeCom OfficePoint, the V24/2 module provides two serial V.24 (RS-232) interfaces for connecting a computer, a printer, or Plus Products (such as Uniform Call Distribution). The V24/1 (not for U.S.) is an under equipped version with only one V.24 (RS-232) interface.
Interfaces: V24 Interfaces (S30807-Q6916-Xxxx) Note: We recommend setting up call detail recording central (CDRC) on interface X2 of OfficeCom and OfficePoint if a V24/2 module is installed.
Use a shielded 9-pin cable as a connecting cable. The wires must be twisted and have a diameter of at least 0.5 mm (24 AWG). The integrated wire shielding must be soldered onto the connector and socket housing of both cable ends. Short-haul modems must be provided if the cable length exceeds 15 m (50 ft.).
Pinout of the V.24 (RS-232) cable for OfficePro
||DCD (Data Carrier Detect)
||RxD (Receive Data)
||TxD (Transmit Data)
||DTR (Data Terminal Ready)
||GND (Signal Ground)
||DSR (Data Set Ready)
||RTS (Request To Send)
||CTS (Clear To Send)
||RI (Ring Indicator)
Pinout of the V.24 (RS-232) cable for OfficeCom and OfficePoint
|Description||Data type||Column name|
|Call duration (s)||integer||CALL_DURATION_S|
Note: Products and companies mentioned here are used only for definition and identification purposes and can be trademarks and/or registered trademarks of the respective companies.