<< Click to Display Table of Contents >>

Navigation:  Troobleshooting >

Garbled data received

Problem: When trying to send data between the DNC and the CNC, the received data is garbled.

 

This is most likely caused by incorrect baud or data bits settings.

 

Check that you are using the correct baud rate

Refer to your CNC's manual for further information.

 

Check that you are using the correct number of data bits

Refer to your CNC's manual for further information.

 

Check that you are using the correct number of stop bits

Refer to your CNC's manual for further information.

 

Machine is using EIA code

Set machine to ASCII/ISO, or select EIA in the port configuration. Refer to your CNC's manual for further information.