Configure the settings on Anilam Crusader II L
| Press keys: [manual] [aux] Parameter number [start] | |
| 7 data bits | AUX 2767 |
| Even parity | AUX 2772 |
| Baud rate 4800 | AUX 2787 |
| Software handshake (Xon, Xoff) | AUX 2791 |
| Hardware handshake (DTR, DSR) | AUX 2792 |
| Transfer from NC to PC in RS-274 format | AUX 2700 |
| Transfer from PC to NC in RS-274 format | AUX 2701 |
| You need to test the RS232 interface on your machine to make sure it is hooked up and working correctly. You need a DB25 loopback connector with pins 2-3 and pins 6-20 connected. Next, start the Anilam RS232 Test procedure: [E-stop In][E-stop Out][Manual][Aux]2740[start] | Result value: 0 - successful test. 38 - board problem. 39 - software problem. |
The COM port settings to connect with
Serial port tab| Machine name | Anilam Crusader II L |
| Serial port | COM2 (or any free COM port) |
| Baud | 4800 |
| Data bits | 7 |
| Parity | Even |
| Stop bits | 2 |
| Use DTR | True |
| Use RTS | False |
| Require DSR | True |
| Require CTS | False |
| Set RTS | False |
| Set DTR | False |
| Software flowcontrol | None |
| Xon char | #11 |
| Xoff char | #13 |
| Format mode | Uniform |
| Format parameters | Program start: % Program end: % Line start: Line end: #0A Skip lines: ; Ignore characters: No characters for remove Remove blank lines: No Program name prefix: : Program starting characters in the file: No Program ending characters in the file: No |
Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25