Logging and capturing data from Mettler Toledo Wildcat Scale

This data is being extracted with help of the "Advanced Serial Data Logger" software only. It may not applicable for other software titles.

DescriptionData typeColumn name
Weight unitsstringWEIGHT_UNITS

COM port settings

For the transmission to function properly, the settings of the following parameters must match at both the computer and the balance. Check the settings at both: the device and the computer.

COM Port Number: Select the port to which your instrument is connected.
Baud rate: 9600 (recommended).
Data bits: 7 (recommended).
Parity: Even (recommended).
Hardwae flow control: Use DTR - enabled.
Software flow control: Disabled (none).

How to configure the logger for the Mettler Toledo Wildcat Scale.

1. Download and install the "Scale data parser" module.
2. Create or modify existing configuration.
3. Go to the "Modules - Query Parse Filter" page
4. Select the corresponding parser module.

The parser for Mettler Toledo Wildcat Scale

Mettler Toledo Wildcat Scale (unipsarser.dll)

Mettler Toledo Wildcat Scale (unipsarser.dll)

The communication setting

Note: Your COM port settings above should match the RS232 settings on the scale.

How to write data from the Mettler Toledo Wildcat Scale to a database.

Please, visit our tutorials section for examples.

How to capture data from USB scale or balance?

Usually the scale vendor provides a driver that can create a virtual COM port for the usb scale. Our serial data logger fully supposts virtual COM ports.

Go to Index page
Mettler Toledo Standard Interface
Mettler Toledo Viva (NCI Protocol)
Myweight HD Series SCI.0 Mode (HD-150,HD-300)
NCI Standard Protocol
NCR Scale,scanner

Note: Products and companies mentioned here are used only for definition and identification purposes and can be trademarks and/or registered trademarks of the respective companies.