OutBack Power (MATE3S) logging. MODBUS registers map.


This data is being extracted with the help of the Advanced Serial Data Logger (MODBUS RTU,ASCII) or Advanced TCP/IP Data Logger (MODBUS TCP) software only. It may not applicable for other software titles.

MODBUS offsetDescriptionUnitsData type
40520AC CurrentAword
40521Phase A CurrentAword
40522Phase B CurrentAword
40523Phase C CurrentAword
40524Scale factor [A_SF] smallint
40525Phase Voltage ABVword
40526Phase Voltage BCVword
40527Phase Voltage CAVword
40528Phase Voltage ANVword
40529Phase Voltage BNVword
40530Phase Voltage CNVword
40531Scale factor [V_SF] smallint
40532AC PowerWsmallint
40533Scale factor [W_SF] smallint
40534Line FrequencyHzword
40535Scale factor [HZ_SF] smallint
40536AC Apparent PowerVAsmallint
40537Scale factor [VA_SF] smallint
40538AC Reactive Powervarsmallint
40539Scale factor [VAR_SF] smallint
40540AC Power FactorPctsmallint
40541Scale factor [PF_SF] smallint
40542AC EnergyWhdword
40544Scale factor [WH_SF] smallint
40545DC CurrentAword
40546Scale factor [DCA_SF] smallint
40547DC VoltageVword
40548Scale factor [DCV_SF] smallint
40549DC PowerWsmallint
40550Scale factor [DCW_SF] smallint
40551Cabinet TemperatureCsmallint
40552Heat Sink TemperatureCsmallint
40553Transformer TemperatureCsmallint
40554Other TemperatureCsmallint
40555Scale factor [TMP_SF] smallint
40556Enumerated value. Operating state word
40557Vendor specific operating state code word
40558Bitmask value. Event fields dword
40560Reserved for future use dword
40562Vendor defined events dword
40564Vendor defined events dword
40566Vendor defined events dword
40568Vendor defined events dword
40630Type of DER device. Default value is 4 to indicate PV device. word
40631Continuous power output capability of the inverter.Wword
40632Scale factor smallint
40633Continuous Volt-Ampere capability of the inverter.VAword
40634Scale factor smallint
40635Continuous VAR capability of the inverter in quadrant 1.varsmallint
40636Continuous VAR capability of the inverter in quadrant 2.varsmallint
40637Continuous VAR capability of the inverter in quadrant 3.varsmallint
40638Continuous VAR capability of the inverter in quadrant 4.varsmallint
40639Scale factor smallint
40640Maximum RMS AC current level capability of the inverter.Aword
40641Scale factor smallint
40642Minimum power factor capability of the inverter in quadrant 1.cos()smallint
40643Minimum power factor capability of the inverter in quadrant 2.cos()smallint
40644Minimum power factor capability of the inverter in quadrant 3.cos()smallint
40645Minimum power factor capability of the inverter in quadrant 4.cos()smallint
40646Scale factor smallint
40647Nominal energy rating of storage device.Whword
40648Scale factor smallint
40649The usable capacity of the battery. Maximum charge minus minimum charge from a technology capability perspective (Amp-hour capacity rating).AHword
40650Scale factor for amp-hour rating. smallint
40651Maximum rate of energy transfer into the storage device.Wword
40652Scale factor smallint
40653Maximum rate of energy transfer out of the storage device.Wword
40654Scale factor smallint
40655Pad register. 
40658Setting for maximum power output. Default to WRtg.Wword
40659Voltage at the PCC.Vword
40660Offset from PCC to inverter.Vsmallint
40661Setpoint for maximum voltage.Vword
40662Setpoint for minimum voltage.Vword
40663Setpoint for maximum apparent power. Default to VARtg.VAword
40664Setting for maximum reactive power in quadrant 1. Default to VArRtgQ1.varsmallint
40665Setting for maximum reactive power in quadrant 2. Default to VArRtgQ2.varsmallint
40666Setting for maximum reactive power in quadrant 3. Default to VArRtgQ3.varsmallint
40667Setting for maximum reactive power in quadrant 4. Default to VArRtgQ4.varsmallint
40668Default ramp rate of change of active power due to command or internal action.% WMax/secword
40669Setpoint for minimum power factor value in quadrant 1. Default to PFRtgQ1.cos()smallint
40670Setpoint for minimum power factor value in quadrant 2. Default to PFRtgQ2.cos()smallint
40671Setpoint for minimum power factor value in quadrant 3. Default to PFRtgQ3.cos()smallint
40672Setpoint for minimum power factor value in quadrant 4. Default to PFRtgQ4.cos()smallint
40673VAR action on change between charging and discharging: 1=switch 2=maintain VAR characterization. word
40674Calculation method for total apparent power. 1=vector 2=arithmetic. word
40675Setpoint for maximum ramp rate as percentage of nominal maximum ramp rate. This setting will limit the rate that watts delivery to the grid can increase or decrease in response to intermittent PV generation.% WGraword
40676Setpoint for nominal frequency at the ECP.Hzword
40677Identity of connected phase for single phase inverters. A=1 B=2 C=3. word
40678Scale factor for real power. smallint
40679Scale factor for voltage at the PCC. smallint
40680Scale factor for offset voltage. smallint
40681Scale factor for min/max voltages. smallint
40682Scale factor for apparent power. smallint
40683Scale factor for reactive power. smallint
40684Scale factor for default ramp rate. smallint
40685Scale factor for minimum power factor. smallint
40686Scale factor for maximum ramp percentage. smallint
40687Scale factor for nominal frequency. smallint
40690PV inverter present/available status. Enumerated value. word
There are more MODBUS items for this device. Please, download the program.


OutBack Power (MATE3S) data logging

Note: Products and companies mentioned here are used only for definition and identification purposes and can be trademarks and/or registered trademarks of the respective companies.