DNC and CNC setting for Mitsubishi - Meldas 60 Series

Set the following parameters on the machine

Use different devices for input and output, but with same port number

IO parameters screen 1/6
9001 (In port #)	2
9002 (In device #)	1
9003 (Out port #)	2
9004 (Out device #)	0
9005 (Tape mode)	2

IO parameters
9101,9201	IN,OUT
9102,9202 (baud rate)	2 (4800)
9103,9203 (stop bits)	1 (one stop bit)
9104,9204 (add parity)	1 (Yes)
9105,9205 (parity)	1 (Even)
9106,9206 (data bits)	2 (7 data bits)
9108,9208 (use DC codes)	3 (yes, DC1 and DC3)
9109,9209 (no parity for DC codes)	1 (Yes)
9112,9212 (CR output)	1 (Yes)
9113,9213 (EIA output)	0 (No)
9114,9214 (Feed chr.)	0 (No)

Set the following parameters on the PC

Serial port tab

Machine name	Mitsubishi - Meldas 60 Series
Serial port	COM2 (or any free COM port)
Baud	4800
Data bits	7
Parity	Even
Stop bits	1

Data flow control tab

Use DTR	False
Use RTS	True
Require DSR	False
Require CTS	True
Set RTS	False
Set DTR	False
Software flowcontrol	Both
Xon char	#11
Xoff char	#13

Data exchange format tab

Format mode	Uniform
Format parameters	Program start: %% Program end: %% Line start: Line end: #0A Skip lines: Ignore characters: No characters for remove Remove blank lines: No Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.