Server software for GlobalSat TR-20X Custom Format 0 GPS Trackers, Vehicle trackers, AVL units
GlobalSat TR-20X Custom Format 0
| Parser item name | Data type | Description |
|---|
| FULL_DATA_PACKET | String | One message from a data packet |
| DATA_PACKET | String | Same as FULL_DATA_PACKET, but without data packet signatures (if exist) |
| DATE_TIME_STAMP | DateTime | Datetime stamp |
| DATA_SOURCE_ID | Integer | Data source ID |
| DATA_SOURCE_NAME | String | Data source name |
| DATA_SOURCE_FULL_NAME | String | Data source full name |
| CLIENTID | Integer | Tracker's remote IP address and port |
| IMEI | String | IMEI |
| DEVICE_ID | String | Device ID |
| TIMESTAMP_UTC | DateTime | UTC date and time |
| TIMESTAMP | DateTime | Local date and time |
| GPS_STATE | Integer | GPS state |
| GPS_STATE_NAME | String | GPS fix mode name |
| LONGITUDE | Float | Longitude 1) |
| LONGITUDE_DEG | String | Longitude (format: deg/min/sec) |
| LATITUDE | Float | Latitude 1) |
| LATITUDE_DEG | String | Latitude (format: deg/min/sec) |
| LONGITUDE1 | String | Longitude (source) |
| LONGITUDE2 | String | Longitude (source) |
| LONGITUDE3 | Float | Longitude (source) |
| LATITUDE1 | String | Latitude (source) |
| LATITUDE2 | String | Latitude (source) |
| LATITUDE3 | Float | Latitude (source) |
| ALTITUDE | Float | Altitude |
| SPEED_KNOTS | Float | Speed (knots) |
| SPEED | Float | Speed |
| SPEED_MPH | Float | Speed (mph) |
| ANGLE | Float | Heading |
| SATELLITES | Integer | Satellites |
| HDOP | Float | HDOP |
| VIN | Integer | Battery level (%) |
| MODE | Integer | Device mode |
| MODE_NAME | String | Device mode name |
| ALARM | String | Alarm status |
| ALARM_SOS | Boolean | Alarm: SOS |
| ALARM_GEOFENCE | Boolean | Alarm: geofence |
| ALARM_SPEED | Boolean | Alarm: over speed |
| ALARM_BATTERY_LOW | Boolean | Alarm: battery low |
| GEOFENCE | String | Geo-fence status |
| MEDIA | String | Report media type |
| REPORT_TYPE | String | Report type |
| REPORT_NAME | String | Report type name |
1) The value is being calculated using the following formula:
d - degree
m - minutes
s - seconds
ms - milliseconds
If a longitude is west or a latitude is south, then the value is being multiplied by –1.