Set the following parameters on the machine
| Select Port | 0 |
| Connection Object | 0 |
| Comp Communication Protocol | 0 (ASCII) |
| Baud Rate | 5 (9600) |
| Character | 0 (7 data bits) |
| Parity | 0 (None) |
| Stop Bit | 0 (1) |
| Response Monitoring Time | 60 |
| Communication Type | 0 |
| DC1 Code | 17 |
| DC2 Code | 18 |
| DC3 Code | 147 |
| DC4 Code | 20 |
| DR Signal Check | 0 |
| Ending DC3 Code | 0 |
| Invalid Data | 1 |
| TRNAS Data Code | 0 |
| End of Block | 1 |
| TV Check | 0 |
| Heading Output | 0 |
| Reset in Slave Communication | 0 |
| Recovery Time of Reset | 1 |
| Data Overwrite | 1 |
| Remote Operation | 1 |
| Check Sum | 0 |
| EIA Character Code (#) | 173 |
| EIA Character Code (*) | 186 |
| EIA Character Code (=) | 194 |
| EIA Character Code ([) | 161 |
| EIA Character Code (]) | 162 |
Set the following parameters on the PC
Serial port tab
| Machine name | Brother - TC-32 A |
| Serial port | COM2 (or any free COM port) |
| Baud | 9600 |
| Data bits | 7 |
| Parity | None |
| Stop bits | 1 |
Data flow control tab
| Use DTR | False |
| Use RTS | False |
| Require DSR | False |
| Require CTS | False |
| Set RTS | True |
| Set DTR | True |
| Software flowcontrol | None |
| Xon char | #11 |
| Xoff char | #12 |
Data exchange format tab
| Format mode | Uniform |
| Format parameters | Program start: %% Program end: %% Line start: Line end: #0D#0A Skip lines: ; Ignore characters: No characters for remove Remove blank lines: Yes Program name prefix: O Program starting characters in the file: No Program ending characters in the file: No |
Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25