DNC and CNC setting for Eckelmann - Viewstar 750
These settings are for the DNC Precision software only. They may not work with other software.
Set the following parameters on the machine
Baud rate | 4800 |
Data bits | 7 |
Parity | E (Even) |
Stop bits | 2 |
Flow control | Xon/Xoff |
Set the following parameters on the PC
Serial port tab
Machine name | Eckelmann - Viewstar 750 |
Serial port | COM2 (or any free COM port) |
Baud | 4800 |
Data bits | 7 |
Parity | Even |
Stop bits | 2 |
Data flow control tab
Use DTR | False |
Use RTS | False |
Require DSR | False |
Require CTS | False |
Set RTS | True |
Set DTR | True |
Software flowcontrol | Both |
Xon char | #11 |
Xoff char | #13 |
Data exchange format tab
Format mode | Data transmit |
Format parameters | Program start:
Program end:
Line start:
Line end:
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix:
Program starting characters in the file: No
Program ending characters in the file: No |
Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
If you have successfully connected DNC Precision
with any other controller not in this list, we would appreciate your sending us the
details to add to the list.
Note: We are not responsible and do not provide guarantee for any of these
settings, that have been sent us by our customers.