bg

DNC and CNC setting for Mazak - T32 M2

These settings are for the DNC Precision software only. They may not work with other software.

Set the following parameters on the machine

Note:The program does not support the Mazatrol protocol
I12
I23
I30
I40
I53
I63
I71
I85
I90
I101
I111
I120
I130
I140
I1530
I160
I240
I580000 0000

Set the following parameters on the PC

Serial port tab

Machine nameMazak - T32 M2
Serial portCOM2 (or any free COM port)
Baud4800
Data bits7
ParityEven
Stop bits2

Data flow control tab

Use DTRFalse
Use RTSTrue
Require DSRFalse
Require CTSTrue
Set RTSFalse
Set DTRFalse
Software flowcontrolBoth
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start:
Program end:
Line start:
Line end: #0D#0A
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No

Null modem cable, without handshake
PC, 9pin, DB9M | CNC, 25pin, DB25
 

Null modem cable, with full handshake
PC, 9pin, DB25M | CNC, 25pin, DB25
 

Null modem cable, without handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
 

Null modem cable, with full handshake
PC, 25pin, DB25M | CNC, 25pin, DB25
 

Go to Index page
Mazak - T plus
Mazak - T2
Mikron CNC
Milltronics - VM-20
Mitsubishi - 300 - 500

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.