DNC and CNC setting for Wenzler MTA-6


These settings for DNC Precision software only. It may not work with other software.

Set the following parameters on the PC

Serial port tab

Machine nameWenzler MTA-6
Serial portCOM2 (or any free COM port)
Baud4800
Data bits7
ParityEven
Stop bits2

Data flow control tab

Use DTRTrue
Use RTSTrue
Require DSRFalse
Require CTSFalse
Set RTSFalse
Set DTRFalse
Software flowcontrolBoth
Xon char#11
Xoff char#13

Data exchange format tab

Format modeUniform
Format parametersProgram start: %%
Program end: #14
Line start:
Line end: #0A#0D
Skip lines:
Ignore characters: No characters for remove
Remove blank lines: No
Program name prefix: O
Program starting characters in the file: No
Program ending characters in the file: No

 

If you have successfully connected DNC Precision with any other controller not in this list, we would appreciate your sending us the details to add to the list.

Note: We are not responsible and do not provide guarantee for any of these settings, that have been sent us by our customers.